宏旭—公路水泥集水槽模具—水泥集水槽模具
The customized height of Expressway catchbasin mold is determined according to the terrain and geological characteristics, and its effect is very good in practical application. We should pay attention to that the outlet of the channel should not be lower than the bottom surface of the drainage channel, and we should consider the natural terrain when designing, and design a more appropriate drainage direction based on it. During the construction of catchbasin mould, the intercepting ditch should be set in the excavation section. The purpose of this is to avoid the possibility of water leakage into the subgrade outside the subgrade, and the excavation work sholeyu����.txtuld be done well. During the excavation, the soil layer structure should be inspected, so that the depth and height of the side ditch on both sides of the road can meet the production requirements, so that the effective drainage can be carried out.
Chinas highway catchbasin mold enterprises should first thoroughly implement and implement, starting from each step, enhance the staffs awareness of energy conservation and environmental protection, scientific management mode, increase efforts to study the manufacturing process of new environmental protection mold, reduce the scrap rate of mold design of Expressway catchbasin, and reduce the resource consumption of mold production, Only in this way can mold continue to create the road of environmental protection, otherwise it will be replaced by new environmental protection technology. The mould of highway catchbasin is a kind of cement mould, similar to the arched chute. It is usually used in dike, river bank, farmland irrigation and water conservancy project.
